How to make a snake using origami

Introduction

How to make a snake in origami

Most of origami figures we know are made ​​from a variety of pre-made units.

You´ll need

  • Sheet of white paper.
  • Scissors and pencil.

Steps

  • How to make a snake in origami

    Take a square piece of white paper, fold it diagonally. Take the top corners and fold it to let the two edges meet.

  • How to make a snake in origami

    Fold the same edges so that the two folds meet in the middle of the paper one more time.

  • How to make a snake in origami

    Now take the short sides of the diamond and fold them in the same way. You will get a diamond with lengthy corner.

  • How to make a snake in origami

    Bend the short part of the diamond at an angle of 90 degrees.

  • How to make a snake in origami

    Bend the latest folded part at an angle of 90 degrees to create head of the snake. Concave tip of the nose inside. Camber the body up following diagonal line to get a volume shape of snake.

  • How to make a snake in origami

    Now bend the trunk of the snake to get a lot of pleats as shown on picture and you’re done.

Warnings

  • Try to keep the fold lines clear to make small pieces noticeable.

Was this article helpful? Share with friends!

Article Info

Author: S. Vogt
  • Likes received:
    Amount of "likes" is based on popularity of author´s articles and reviews in social networks. The more "likes" your publications get, the higher the total number of your "likes".
    741810
  • Reviews count: 3
  • Comments count: 2
  • Articles count: 23

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *