How to make a seal using origami
Today we will continue the marine origami theme. These are steps to make a seal using the ready unit “fish”.
- The completed fish unit.
- Table or any flat surface.
Place the fish unit on table.
Fold the figure along the longitudinal center line.
Bend the back fin, it should be parallel to the center line. Take about 1 inches (3 cm) apart and mark the fold. Make 0.8 inches (2 cm) fold on the right acute angle.
Bend the tip of the corner according the fold line and bend it back up to the top corner.
Bend the torso of your seal as shown in the picture. Head of the seal will be upright.
Turn the seal’s head to a side in accordance with the corner line in step 4.
Bend the tail in the shape of the rear flippers. Fins should be bent in one plane with table as shown in the picture.
Now flatten the lateral fins and straighten the body. Your fur seal is done.
- Pay attention to the proportion of the fur seal as you make it.
- How to make the module “fish” here.
Was this article helpful? Share with friends!